返回列表 回復 發帖

新手求教各師兄

事原本人買車約1年多07年RG1,買車回來先換了波箱油,油格,偈油,火咀等等損耗品,半年換一次偈油及油格,兩次偈油都係換5w40,剛驗完車今次換油時,師父話副偈嘈,所以幫我用咗10w40,我再加咗半支ER,因第一次加所以入半支ER,之後師父話洗埋蝴蝶葉,完成後部車轉數不定N波時有成千幾轉,師父話係,揸一輪就會回覆正常,但過兩日都無改善,睇返之前ching post,話用古老方法可以reset部車電腦,我就試下跟住做,先鬆電磁,之後裝回,扭兩格匙,等錶台d燈閃完後之係着車P波3000轉hold約6分鐘水溫去到1百度,着咗風扇,風扇運作完後鬆油門,轉數去返7百幾,好次正常返咁,揸了幾日車發現slow車時轉數由650轉至750轉不定,仲有時有一下落到5百幾轉,個吓架車有少少chok,係咪有地方做錯咗,是否要去車房reset電腦呢?
事原本人買車約1年多07年RG1,買車回來先換了波箱油,油格,偈油,火咀等等損耗品,半年換一次偈油及油格,兩次偈油都係換5w40,剛驗完車今次換油時,師父話副偈嘈,所以幫我用咗10w40,我再加咗半支ER,因第一次加所以 ...
jacko 發表於 17-9-2015 23:24
RG丶RK 通常洗完風門都應該要 reset 電腦一次喎
四平八穩    舒適駕駛     樂趣無窮
請問如何reset?
我RG洗左蝴蝶奄都有類似情況,轉數會跳來跳去,N波時比起洗之前高轉左
請問如何reset?
我RG洗左蝴蝶奄都有類似情況,轉數會跳來跳去,N波時比起洗之前高轉左
JayC 發表於 18-9-2015 00:11
車房 C Fu 吉電腦 reset 囉
四平八穩    舒適駕駛     樂趣無窮
本帖最後由 sammykwan 於 18-9-2015 21:11 編輯
事原本人買車約1年多07年RG1,買車回來先換了波箱油,油格,偈油,火咀等等損耗品,半年換一次偈油及油格,兩次偈油都係換5w40,剛驗完車今次換油時,師父話副偈嘈,所以幫我用咗10w40,我再加咗半支ER,因第一次加所以 ...
jacko 發表於 17-9-2015 23:24
1st of all, since the RPM is down to normal range, you have reset the ECU correctly.

Now the problem is "you think" the RPM is dropped too low at some point (below 600rpm)
If I were you, I will not use 10w40, as it will take quite a while to warm up the engine oil to get into working temperature for this engine (it could cause low oil pressure when it first started). I would like to know if low RPM is only happened at cold engine or at anytime even the engine is warmed up.

One thing you may want to also check is open up the hood, and see if all the hose are fixed correctly, especially the air filter box is closed tightly (there are 2 clips to lock the lid)

Anyway, it may be just the idle air control valve takes abit more time to relearn from the new data after cleaning. Drive for a week more to see if everything gets back to normal.
災後重建中.......
本帖最後由 sammykwan 於 18-9-2015 02:17 編輯
請問如何reset?
我RG洗左蝴蝶奄都有類似情況,轉數會跳來跳去,N波時比起洗之前高轉左
JayC 發表於 18-9-2015 00:11
睇返之前ching post,話用古老方法可以reset部車電腦,我就試下跟住做,先鬆電磁,之後裝回,扭兩格匙,等錶台d燈閃完後之係着車P波3000轉hold約6分鐘水溫去到1百度,着咗風扇,風扇運作完後鬆油門,轉數去返7百幾,好次正常返咁
in the 1st post already mentioned.....

or see this post http://www.stepwgnhk.com/viewthr ... amp;highlight=reset
災後重建中.......
多謝各位幫忙,現有以下情況
試過方法後,slow車轉數以回落,但現有一問題,轉數返宜底咗,大約6百幾轉,會有時落到5佰幾轉,間唔中都會死火,請問是否要去reset電腦先可解決問題,還是有其他原因?
多謝各位幫忙,現有以下情況
試過方法後,slow車轉數以回落,但現有一問題,轉數返宜底咗,大約6百幾轉,會有時落到5佰幾轉,間唔中都會死火,請問是否要去reset電腦先可解決問題,還是有其他原因? ...
jacko 發表於 27-9-2015 12:56
just run the car with a week or 2 to see.....the ECU should relearn after getting a few more rides of data.
災後重建中.......
返回列表